Pikachu Lightbox
Copyright Claim
Pikachu Lightbox
Boost
84
132
13
Print Profile(3)
0.2mm layer, 3 walls, 20% infill
Designer
4.7 h
3 plates
0.2mm layer, 3 walls, 20% infill
4.7 h
3 plates
0.2mm layer, 3 walls, 20% infill
2.9 h
2 plates
Open in Bambu Studio
Boost
84
132
13
2
202
103
Released
Description
A Pikachu lightbox from the Pokemon franchise designed in Fusion 360. There is the main body which is printed face down at a .2 layer height, then the back panel which is printed face up at the same layer height. The back panel has two cutouts for the USB-C connected to power the internal LEDS as well as a switch to turn the lights on and off. Links for the USB-C connector, Switch, and LEDS I used are below. I included both a blank back panel as well as a back panel with the cutouts I use for the power and on/off switch
Link for LEDs, Switches, and other components used: https://bit.ly/m/Additive-Imprints
Documentation (1)
Assembly Guide (1)
Assembly Guide_d5cfa6d4-43ff-4cfd-b09a-cb6532ea9384.pdf
Comment & Rating (13)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
came out amazing
the file is great
The designer has replied
0
Reply
awesome, I’m glad it worked out for you! Thanks for the feedback!
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 20% infill
ok
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Fantastic and easy print, love this little pikachu!
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Turned out great, very adorable going to give to my brother
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
J'ai juste retiré le marron des yeux.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld