Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.2 h
2 plates
Open in Bambu Studio
Boost
24
60
26
0
97
94
Released
Description
First attempt at a lightbox for my daughter who loves anything anime.
Update 12/26/2023: Uploaded revised files for hanging and standing versions of this with new design for putting back plate on with ease.
Standing Version : https://makerworld.com/en/models/108644#profileId-116014
Hanging Version : https://makerworld.com/en/models/108642#profileId-116009
Comment & Rating (26)
All
Love the design! but the lid was way too difficult to put on as it didn't align properly. Had to cut a lot of tabs for it to fit. Also the hole on the bottom for the cord to come out makes the lightbox tilt making it not sit straight. over all i do love the design, keep up the good work.
The designer has replied
3
Reply
This was my first attempt at it. When I get the chance to redesign it I will also put the hole on the back plate with the Usb C connector dimensions. 👍
0
Reply
New versions are up if you would like to check them out! Thanks for your feedback on the original!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out fine with a .4 nozzle, at .12. However attaching the back plate to the front was a nightmare, I had to snip off various pieces of the back plate so that it would mate with the front. Perhaps redesign the back plate so that it fits into the front easier. Otherwise its good.
The designer has replied
2
Reply
Thanks for the input! I may redo the model with a bigger offset to minimize some of the sharper edges when snapping it together.
(Edited)1
Reply
New versions are up if you would like to check them out! Thanks for your feedback on the original!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
back plate dont fit
The designer has replied
0
Reply
it fits, its just a PITA to get it to.
0
Reply
I haven't printed a light box yet but I wanna try doing one, does this print have the hole for the light cord to go through it or do I have to make it myself?
The designer has replied
0
Reply
It has a hole through the bottom. This was my first lightbox so it is a little difficult to get the back plate on though.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it prints nice. can't get the back plate on
The designer has replied
0
Reply
It is a PITA to get the back on this one.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
kids love it
The designer has replied
0
Reply
Awesome!
0
Reply
please i want the back cover
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld