Sovol 3D Dual Filament Stand 30mm / Filament dryer
Remixed by
Copyright Claim
Sovol 3D Dual Filament Stand 30mm / Filament dryer
Remixed by
Boost
12
25
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Boost
12
25
10
1
55
51
Released
Description
Sovol Filament Dual Dryer Stand
Höhe 30mm
DUAL Sovol 3D Filamenttrockner der unten zu viel wärme abstrahlt, den Stand etwas höher gemacht.
Der Abstand von 30mm zur Box bzw. Unterboden von der Box, gibt es genügend Platz zum ableiten der Wärme.
Kleine Verbesserung der Stabilität und Höhen Anpassung.
Remix aus Thingiverse von UncleSash
==========================================================================================
Sovol Filament Dual Dryer Stand
Height 30mm
DUAL Sovol 3D filament dryer that radiates too much heat at the bottom, made the stand a little higher.
The distance of 30mm to the box or the bottom of the box means there is enough space to dissipate the heat.
Small improvement in stability and height adjustment.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed nice and easily.
-- printed in eSun PLA+ White
-- applied fuzzy skin (contour distance 0.5, thickness 0.1)
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great fix and fit
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld