Napkin holder by Challapenjo

Challapenjo

Household>Other House Models

GIF

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.12mm layer, slower speed for outer walls (30 mm/s) to make the GOLD shiny

Designer

13.5 h

4 plates

5.0(3)

Boost

Released

Description

Enjoy my royal napkin holder!

NO support needed
NO additional tools required for assembly
uses standard format for napkins (edge length when folded: 16,5 x 16,5 cm ≙ full lenght unfolded: 33 x 33 cm) - if you need other formats, simply scale everthing to the size you need

I used Bambulab PLA Silk Gold for my print but you can use any color your like. The gold comes out more shiny if you print it at a slower speed, that's why my settings are 30 mm/s for outer walls.

The texture PEI plate also helps with a great gold finish on the surfaces.

Assembly:

Very easy! My model uses a press fit to hold all parts together. Carefully clip everything into the base plate. The lever can be pushed into the back plate. Secure it with the hinge holder afterwards.

Comment & Rating (5)

@Mitch23

Print Profile

0.12mm layer, slower speed for outer walls (30 mm/s) to make the GOLD shiny

Looks absolutely stunning, especially using the AliExpress build plate that leaves that cool pattern on there. As you can see from my photos, I did have issues printing the two little pieces. I tried multiple times, and it would not stick to the plate. I ended up having to use a raft. Once I enabled the raft it worked fine despite the issues with printing I would highly recommend this. iIt looks stunning. I get compliments on it all the time. I have already made one for a friend and one additional one for my mother. Just use a raft for the small pieces and you will be good to go.