NFO Lightbox

Copyright Claim

NFO Lightbox

Boost
2
4
3

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
6.2 h
2 plates
5.0(2)

Boost
2
4
3
2
9
4
Released

Description

Here was a request that I completed for NFO Lightbox. Oriented face down with all settings in print profile. Had to up the flow rate to 1.05. If you have any issues with tiny holes, try pushing it up to 1.06 or 1.08 to make sure to get all the tiny corners. Ability to route the light cable through the side hole if mounted on the wall, or if you're going to use the stand, i think it looks a bit better to route it through the bottom of the backplate where i have left a little gap. Hope it works well!

Note: if you want a wall art version of this, all you have to do is cut at the point where the wall is no longer on the side, take off uniform scale, and then scale up the z to around 2 or 3mm. whatever you prefer.
The light strip i use can be found here :
https://www.amazon.com/dp/B0BYJ8MW2T?ref=ppx_yo2ov_dt_b_product_details&th=1 .

Let me know what you think!
An alternative if you want RGB lights are these https://www.amazon.com/gp/product/B0BG885LVL/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 .

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Greqt print and detail! Thank you for creating this file!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice model, but there is little reason for two holes for light strip on side and the back. my concern would be the side hole could bleed light. of course a piece of black tape solves this, but it's my opinion on how the model can be improved. black and gold came out nice.
(Edited)
0
Reply
very nice
0
Reply
No more