Flow Test - Visual and Fast!
Copyright Claim
Flow Test - Visual and Fast!
Boost
13
31
28
Print Profile(2)
0.2mm layer, 2 walls, 20% infill
Designer
16 min
1 plate
0.2mm layer, 3 walls, 10% infill
16 min
1 plate
Open in Bambu Studio
Boost
13
31
28
1
160
195
Released
Description
This is a test model that can be printed quickly. By looking at it you can see if you set your flow (aka extrustion multiplier) correctly.
There is couple of surfaces with overlaping features, so you can look if you have some gaps, or overextrusion. It uses less than 4g of filament and prints in about 6-15 minutes - depending on your printer. It is suitable for both 0.4 and 0.6mm nozzles.
Printing instructions
- 0.2mm layer height
- 2 walls, 3 top and bottom layers
- 20% infill
I have found that for me 1.0 (100%) flow usually works for PLA, and 0.94 (94%) for ASA. When I get a new colour, I try these defaults on this print and if needed, change the flow by 0.01 (1%) either up or down.
My Twitter :)
In case you have any requests, feel free to send me a message and I will try to help you out!
Comment & Rating (28)
All
Print Profile
0.2mm layer, 2 walls, 20% infill
Gold test!
The designer has replied
1
Reply
Glad you like it!
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Very good and fast
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
said what it would do
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Worked perfectly fine
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
that's gonna be my favorite test part
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Worked well. Thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Very good comprehensive test
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
looks great thanks easy 2 print
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Cool
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
?
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld