I created this table for light use. Using it for the outdoor picnic. However, I do not put heavy stuff on the table. I mainly put some food and snack on the table when we go out picnic.
- You need to print 4x of the table (1 quarter).
- You can choose any color for the table top.
- After printed 4 table tops, you can connect them using the bolt and nut that i shared in print profile (3mf)
- The bolt and nut are not created by me. I downloaded some times ago but I can't remember where i did download.
- If you do not want to connect the 4 table tops using the bolt and nut, you can use cable tight too. I tried and it is pretty ok too.
- For the table leg, I print the diameter at 50mm. It is a bit loose when you assemble to the table. You can choose to enlarge the diameter a little bit, and you can increase the height of the leg to fully utilize X1C's full Z height, if you wish too.
- You can print in various colors. I tried to utilize my remaining filaments.
- I print in PLA. But i plan to print another set in PETG in future.
That's all and happy printing!