I created this table for light use. Using it for the outdoor picnic. However, I do not put heavy stuff on the table. I mainly put some food and snack on the table when we go out picnic.

1. You need to print 4x of the table (1 quarter).
2. You can choose any color for the table top.
3. After printed 4 table tops, you can connect them using the bolt and nut that i shared in print profile (3mf)
4. The bolt and nut are not created by me. I downloaded some times ago but I can't remember where i did download.
5. If you do not want to connect the 4 table tops using the bolt and nut, you can use cable tight too. I tried and it is pretty ok too.
6. For the table leg, I print the diameter at 50mm. It is a bit loose when you assemble to the table. You can choose to enlarge the diameter a little bit, and you can increase the height of the leg to fully utilize X1C's full Z height, if you wish too.
7. You can print in various colors. I tried to utilize my remaining filaments.
8. I print in PLA. But i plan to print another set in PETG in future.

That's all and happy printing!