Keychain for 1€ + Coins with car logos
Boost
40
55
17
Print Profile(9)
Coin Holder 0.12mm layer, 3 walls, 15% infill
Designer
29 min
1 plate
Skoda Logo Coin 0.16mm layer, 4 walls, 15% infill
Designer
15 min
1 plate
Seat Logo Coin 0.16mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
VW Logo Coin 0.16mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
Click to see more
Boost
40
55
17
1
112
95
Released
Description
Keychain for the 1 euro coin for shopping cart.
For now I have coins with this logos:
VW:
Skoda:
Mazda:
Seat:
Toyota:
Peugeot:
Opel:
Land Rover:
Comment & Rating (17)
All
Print Profile
Skoda Logo Coin 0.16mm layer, 4 walls, 15% infill
perfect size 1€
The designer has replied
1
Reply
looks nice, thanks for your feedback.
0
Reply
Print Profile
VW Logo Coin 0.16mm layer, 2 walls, 15% infill
good
0
Reply
Print Profile
Seat Logo Coin 0.16mm layer, 2 walls, 15% infill
looks perfect but the holder is really too hard to works. I used support maybe it's the problem
The designer has replied
0
Reply
I printed a lot of them and as you say some of them came out pretty tight. I had to do a bit of cleaning because of supports and also they get a bit looser after bit of using.
What supports did you use?
(Edited)0
Reply
I don't remember but probably the easiest one like ''enable support'' and leave as default
0
Reply
Print Profile
Peugeot Logo Coin 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Coin Holder 0.12mm layer, 3 walls, 15% infill
0
Reply
Print Profile
Coin Holder 0.12mm layer, 3 walls, 15% infill
0
Reply
Print Profile
Coin Holder 0.12mm layer, 3 walls, 15% infill
0
Reply
Print Profile
Seat Logo Coin 0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Opel Logo Coin 0.16mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
Seat Logo Coin 0.16mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld