Tie Fighter in Hyperspace

it's a very simple print that can be print-in-place, it's 4 colors including the tie fighter.

if you use my 3mf file everything is indicated there and it is easy to print, if you decide not to use my file follow the instructions below

Instructions:

1. Print the hueforge print (0mm - 3.08mm) at 100% infill.
2. The Tie Fighter portion of the print (3.08mm - 70,45mm) should be printed at 5% infill, with 2 wall loops. I used a layer height of 0.20mm.
3. You can achieve this by using a layer height modifier in your slicer to modify layers 3.08mm-70,45mm.
4. You do not need any supports for this print.

Swap Instructions for the hueforge base:
- Start with Black
- At layer #17 (1.52mm) swap to Blue
- At layer #23 (2.00mm) swap to Grey

- At layer #26 (2.24) swap to Withe up to the layer 2,96

- then change color for your Tie Fighter

If re-scaling model make sure not to alter the Z height of the model