A replacement saddle for a Kala Waterman ukulele. This ukulele apparently has a very high action. This saddle is around half the thickness of the original, and drops the strings by around 3.5mm. Print it so that the saddle is printed vertically (like a tower), otherwise all the little lugs will snap off. Use a hard plastic, like PLA so the strings don't wear through the plastic.
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
Lots
Notes:
Print it vertically, like a tower, using a hard plastic.
Category: Music