Search models, users, collections, and posts
Flying snowflake
IP Report
Print Profile(1)
0.28mm layer, 2 walls, 10% infill
Designer
4.7 h
4 plates
Open in Bambu Studio
Boost
39
85
10
4
98
49
Released
Description
No support
After printing, for the one in the air all you have to do is break out the small tower in the middle, rotating is the trick.
You should hold the snowflake firmly for this.
For the one the plate, bend the plate then hole the snowflake where it's loose and bend again.
I recommend white Silk PLA, gold and silver have also given quite good results.
I optimized this print profile for BambuLab Wihte Silk. And Sunlu also worked without a problem.
Make sure that you use dry filament, you may still have a little stringing. If you want to optimize this, reduce the temperature in 3 °C steps. I also had results that I was happy with, but I like to hear the feedback.
Boost Me (for free)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)