Search models, users, collections, and posts
Magnet Setter
IP Report
GIF
Print Profile(2)
0.2mm layer, 2 walls, 20% infill
Designer
2.2 h
3 plates
0.08mm layer, 2 walls, 15% infill
54 min
1 plate
Open in Bambu Studio
Boost
816
2312
183
77
2 k
1.1 k
Released
Description
Used to place small magnets with proper orientation. Hold slider down, attracts magnet, place in proper location, pull slider back, magnet is released. Can be used to place any size of small magnets.
Recommended you print two to have one for each orientation. I included recesses in the top of the slider and cap to use a pen spring to hold the slider down, but it works fine without.
Required:
3x3mm cylinder magnet
Pen spring (optional)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (183)