Under desk drawer
Under desk drawer
Boost
23
40
8
Print Profile(1)
0.2mm layer, 2 walls, 5% infill, with irong on front panel
Designer
12.2 h
2 plates
Open in Bambu Studio
Boost
23
40
8
0
96
39
Released
Description
Under desk drawer, there are some holes for putting metal steel bars for reinforcement but are not necessary, up to 3mm diameter.
Screw holes are M2.5x20mm, they are needed to attach the slider to the table.
Print options:
Resolution: 0.2
Infill: 15%
Ironing on the front panel
PLA
Comment & Rating (8)
All
So I just printed this out. There is no way in hell the steel bars or not necessary. How else will you hold this thing together?!
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill, with irong on front panel
pretty good Settings and size, would be good if there are some instructions how to set it up. The side wich was Ironed it should be supposedly be outside Racing side, is actually inside.
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill, with irong on front panel
Drawer turned out great, thanks for sharing this, works out much better for me than the small drawers will little room! Fantastic!
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill, with irong on front panel
Printed and turned out great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill, with irong on front panel
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill, with irong on front panel
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill, with irong on front panel
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill, with irong on front panel
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld