Giant Lego-Like Hair! (10:1 Remix)
Copyright Claim
Giant Lego-Like Hair! (10:1 Remix)
Boost
92
124
6
Print Profile(1)
Split w/ 0.16mm layers
Designer
14.1 h
2 plates
Boost
92
124
6
0
158
40
Released
Description
I couldn't find any 10:1 Lego Hair I liked (and was easy to print) so I came up with my own model!
The hair is cut in half for easier printing and sized to fit 10:1 Lego-like megafigs, namely Julia's megafig (which I used to take the pictures).I also uploaded the un-cut hair.stl if you'd like to cut it yourself!
Supports are enabled by default. Will require some glue to put together, but in my experience both sides of the hair stay on the head by themselves (for the most part). I'll eventually add a version with connector pins/pegs for easier assembly.
Comment & Rating (6)
All
Print Profile
Split w/ 0.16mm layers
I print it as one piece so maybe that was part of the issue. The supports on the straight side hair pieces busted off one of them. and one of the hair nodules didn't finish printing correctly. I'm going to try to fix that with the filament pin. otherwise it looks pretty good.
(Edited)
0
Reply
Print Profile
Split w/ 0.16mm layers
printed as one piece with support. only had a small area which didn’t print to well.
0
Reply
Print Profile
Split w/ 0.16mm layers
0
Reply
Print Profile
Split w/ 0.16mm layers
0
Reply
Print Profile
Split w/ 0.16mm layers
0
Reply
Print Profile
Split w/ 0.16mm layers
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld