Forklift Doorstop
Copyright Claim
Forklift Doorstop
Boost
13
27
5
Print Profile(1)
PLA | support | sideways | 0.2mm layer, 2 walls, 20% infill
1.3 h
1 plate
Boost
13
27
5
0
51
28
Released
Description
Why was the forklift used as a doorstop? Because it always dreamed of breaking into interior design, but it never expected to end up 'stuck' in an entryway!
How to print it
Use a 0.4 nozzle; 0.2 layer; 20% infill; use tree supports to hold up the overhanging parts.
Comment & Rating (5)
All
Print Profile
PLA | support | sideways | 0.2mm layer, 2 walls, 20% infill
cute and functional
(Edited)
0
Reply
Print Profile
PLA | support | sideways | 0.2mm layer, 2 walls, 20% infill
prints very nice I have scaled %200 and %50 thay also printed without problems
supports are easy to remove I have also tried printing %50 scaled model with bambu support and PETG as support interface
I strogly advise printing without using any other matterial as support interface.
But if you have ..use PETG BECAUSE bambu support w leaves residues on surface
But be sure to use suggested flushing volumes otherwise PETG supported model easily broken
0
Reply
Print Profile
PLA | support | sideways | 0.2mm layer, 2 walls, 20% infill
The designer has replied
0
Reply
Thank you for dedicating a moment to provide your valuable feedback on this profile. Did you experience any problems with the profile?
0
Reply
Print Profile
PLA | support | sideways | 0.2mm layer, 2 walls, 20% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld