Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
2.8 h
1 plate
Open in Bambu Studio
Boost
104
195
32
5
467
261
Released
Description
My forklift runs wherever there's a need, sometimes stopping doors, sometimes taking phones for a walk, here's the phone holder version.
How to print it: use a 0.4 nozzle; 0.2 layers; 20% infill, use tree supports. Printing time is about 3 hours with a Bambulab X1 C.
Comment & Rating (32)
All
Print Profile
0.2mm layer, 2 walls, 20% infill
good i did pull off the roof though
The designer has replied
1
Reply
You didn't manage to print it or you simply prefer it without? I could draw a version without a roof...
0
Reply
I try with color
The designer has replied
1
Reply
It's beautiful! Great idea!
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Made this for my buddy who is forklift certified. It’s basically as good as the real thing.
(Edited)
The designer has replied
1
Reply
Thanks a lot :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
nice print, supports were a bit snug but removable
The designer has replied
1
Reply
Thanks a lot :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
very good Quality
Thank you
The designer has replied
0
Reply
Thanks a lot :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
perfect print
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
It looks so cool but it's a little too tip happy and the supports leave a really rough finish. I'm not sure if I wasn't calibrating but the layer lines were rough. It's awesome either way since it's been everywhere around the house and work.
2
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
The GF loves it! We printed it in a rainbow filament and the gradients turned out awesome one it! cool little phone holder.
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
works as intended
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Top
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld