Print Profile(2)
0.16mm layer, 1 walls, 0% infill
Designer
1.6 h
1 plate
0.16mm layer, 1 walls, 0% infill
1.6 h
1 plate
Open in Bambu Studio
Boost
57
117
28
1
271
208
Released
Description
A small, simple vase, but if you print it with bi- or tri-color PLA, you can create real magic. You can print it either normally or in vase mode.
Comment & Rating (28)
All
Print Profile
0.16mm layer, 1 walls, 0% infill
(Edited)
1
Reply
Print Profile
0.16mm layer, 1 walls, 0% infill
bottom Is too thin. it loses some water
(Edited)The designer has replied
0
Reply
Hi, forgive me, but the vase in the image attached to your comment is not my original vase, are you sure I'm talking about my model?
0
Reply
Replying to @Sparks3D
sorry, my mistake. Just removed it
0
Reply
Replying to @bypo
No problem ;)
0
Reply
Print Profile
0.16mm layer, 1 walls, 0% infill
Strength Issue
The designer has replied
0
Reply
I'm sorry to hear that you've had issues with this model, may I ask if you used the shared parameters? I assure you this is one of my most downloaded and printed models and I've never received negative feedback, can I be of assistance?
0
Reply
Replying to @Sparks3D
I used the standert settings, but the walls of the vase was so thin, that I broke when I took the of the plate.
it was a real nice design
0
Reply
Replying to @maxicoon
:(
0
Reply
what’s the size of the hole at the top?
The designer has replied
0
Reply
27mm in the neck, 30mm on top
0
Reply
Print Profile
0.16mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.16mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.16mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.16mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.16mm layer, 1 walls, 0% infill
1
Reply
Print Profile
0.16mm layer, 1 walls, 0% infill
1
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld