Gridfinity with pin storage box 5x5x6u

Excellent 5x5x6u gridfinity storage case remixed to use gridfinity with pin base which allows compatible bins to click securely into place with no need for magnets. It makes it an even more secure storage box.

5x5x9u version is here

4x4x6u version is here

3x3x6U version (A1 mini compatible) is here

Print all three plates ideally in PETG

Slide catches into the rails on the sides (if using, the plate just has 2 for the front) and the front of the base

Insert the hinges into the holes on the back of the base

Align the free ends of the hinges and secure the lid

Close the catches on the front, tolerances are tight but they should click in, you may need to file them a bit, but push hard and they will go.

Insert handle and pins for handle, you will need to push these hard as well, the wider end is on the inside and you will see that the flat surface slips over the ridge there. you will probably need to use these in with a tool, they will go.

You can find a full set of bins to fit here

And the original designer of gridfinity with pin One Maker Show has been putting together a nice collection of gridfinity with pin designs which are also compatible with this system.