Detergent Cup Holder
Copyright Claim
Detergent Cup Holder
Boost
16
22
15
Print Profile(1)
0.3mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
16
22
15
0
39
65
Released
Description
The ones sold online are all foldable versions, and I think it’s more reassuring to have them all in one piece.
Comment & Rating (15)
All
Print Profile
0.3mm layer, 2 walls, 15% infill
my issue is that the clip broke and I believe that it is because of the thickness being so thick it could bendy easy and sit there waiting
(Edited)The designer has replied
0
Reply
The piece of mine has been hanging on my laundry detergent bottle since it was printed, and it still survives. It may be due to the difference between filaments. It is recommended that you adjust the layer height to 0.2 and increase the printing temperature by 5 degrees so that the layers can be better integrated.
0
Reply
Replying to @user_3257010834
ok thank you ill try printing it again and give you an update.
0
Reply
Replying to @xswords
Thank you for being willing to try again, although we may both use the same printer, there are too many other variables.
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
Designed well and printed nicely on my A1 mini.
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
works great and fits good on Gain jug. Printed in Bambu basic PLA.
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
Design isn't great but it works. A few tweaks and it wouldn't need supports.
1
Reply
I should have paid more attention and made the hole a little larger. Other then that it worked perfectly.
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld