DNA Double Helix Earring
DNA Double Helix Earring
Boost
56
131
8
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
56
131
8
0
106
51
Released
Description
DNA earrings, good for the lab!
Printed with .12 settings on the X1C using tree supports, carefully took a while removing support.
The red images are on the x1c and the green images are in resin on an anycubic photon mono, if you'd like to give it a go in resin..
Comment & Rating (8)
All
Supports were near impossible to remove without breaking structure and structure was not smooth because of it. Also way bigger that I had anticipated.
Used PLA.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
too tedious to remove from supports. I printed it with generic PLA Silk.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
stupendi.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
la impresión salió bien , pero con tanto soporte al quitarlos se rompió
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
supports were a pain to get off but it’s a fun design. much bigger then I anticipated
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
This is still quite fragile and very easily breaks. Keep super glue handy.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld