Search models, users, collections, and posts
Universal Pegboard System
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.1 h
3 plates
Open in Bambu Studio
Boost
29
116
5
2
116
59
Released
Description
I got super annoyed with all of the universal adapters for the skadis, and didn't want to add another peg board either on top of the pegboard that came with my work bench, or obviously replace it. So, I just decided to make a modular version for my pegboard. Use this as you see fit, let me know if helped, and as I make any updates to mine, I'll add them here. Thanks.
- Caliper Holder V7.stl
- Just the Caliper holder, not the peg board side.
- Jewlers-Precision screw driver holder v3.stl
- Fits my Moody drivers, and my Snap-on drivers. Your mileage may vary, for the hole sizing.
- Universal Pegboard holder.stl
- This is matched for most standardized pegboard spacing and hole sizing.
- Universal Pegboard system.3mf
- Bambu 3mf. I did not change anything for my printer, nor my filament, and ran the base profile. I recommend using your own settings, to ensure that you have a good outcome for your print.
- Universal Pegboard System.f3d
- Fusion 360 file, please excuse my chaotic design process, I was not sure where I wanted to go with this, and it was very much a trial and error type of process, since that was much faster for me.
- Universal Pegboard System.obj
- Same as F360 file.
Documentation (1)
Other Files (1)
Universal Pegboard system.pdf
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)