Phone Stand
Remixed by
Phone Stand
Remixed by
Boost
21
47
26
Print Profile(2)
0.2mm layer, 4 walls, 15% infill
Designer
2.2 h
1 plate
0.2mm layer, 4 walls, 30% infill
2.4 h
1 plate
Boost
21
47
26
1
213
181
Released
Description
This is a phone stand I modified to fit my phone with the case on it. The brackets are longer to accommodate my chonkier phone+ case. I gave it some extra room on top of that so I didn't have to line things up perfectly, making it easier to put the phone in the stand.
Comment & Rating (26)
All
This profile printed really well given it had no supports. Just a little bit of errors/stringing on the underneath side of the arch. Still very nice without any supports at all.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
bene ma sui supporti ci sono dei errori
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Simple yet easy phone stand. No issue with printing and it works as intended. Pixel 7
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
came out good
0
Reply
Boosted
good
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
very useful!
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Passt sehr gut beim iPhone 13 ( + Cover ).
Sieht bei mir leider unter den Supports nicht so schön aus ( Baum ).
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Came out really clean. Fits my Samsung S10 in a case perfectly.
(Edited)0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld