Jason Knife
Copyright Claim
Jason Knife
Boost
4
6
5
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
52 min
1 plate
Open in Bambu Studio
Boost
4
6
5
0
8
12
Released
Description
Jason Knife: Everything is already set up in the slicer you just need to download the file and press print.
The knife is 245mm long and 2mm thick as i have made them to suite a photo frame.
please leave a like or a comment and show how you're print turned out, if the print for some reason failed just comment below and i can edit the slicer to suite you're printer.
Thankyou
Comment & Rating (5)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
looks good other than the lines at the bottom of the handle which were caused by the extrusion calibration which I run before prints. had I thought about that beforehand, I could’ve made the appropriate changes
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld