Search models, users, collections, and posts
SD Card Holder
Remixed by
IP Report
Print Profile(6)
single SD card wallet
Designer
1.2 h
1 plate
tripple sd card wallet
Designer
1.7 h
1 plate
double SD card wallet
Designer
1.4 h
1 plate
0.2mm layer, 3 walls, 15% infill
1.9 h
2 plates
Click to see more
Open in Bambu Studio
Boost
456
1267
289
128
2.8 k
2.1 k
Released
Description
A remix of @artsef_153325 TF & SD Card Holder/ Wallet on Printables. I love his design but since I'm not using a TF card I thought I'd remix it and make some small QoL changes
- Add chamfers below the wallet case to avoid overhanging walls.
- Slight tweaks to the tray to make accessing the lower tray easier when using a double or triple wallet.
- Each tray can currently hold up to 4 SDHC cards, I may add more slots for Type A CF cards and TF cards in the future.
Note:
Because the design relies on friction to hold the tray in place and allow it to slide in and out, the fit may vary depending on the 3D printer, printer calibration, and filament type. As a result, the tray might not fit perfectly into the case.
If the tray is too tight to insert, you can lightly sand it with sandpaper or slide it in and out a few times to help it fit better.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (289)