Search models, users, collections, and posts
Line clip
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, seam in back
Designer
14 min
1 plate
Open in Bambu Studio
Boost
21
49
3
1
41
31
Released
Description
I couldn't find any line clips in the local stores so I made my own now that I can't go fishing.
The rod I designed it for is 10mm wide and the inside of the clip is 9,5mm. If you need it for a different size rod you can easily scale it. I found that a slightly thicker rod is fine. When it's too thick the clip will jump off.
Printed in PLA although PETG would probably be better. Make sure seam position is on the back to prevent creating sharp edges that damage your line.
Tight lines!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)