Impossible Bracelet

Introducing the “Impossible Bracelet”! Print in place! No post processing! Multi color stripes with no AMS necessary and very little waste with AMS. Easy print with no supports. Ultra strong for its small size. Innovative side printed design and chamfered edges for ultra smooth and comfortable to wear surfaces. Simple but effective clasp (slide in sideways, just pull apart to remove). My first item to include my revolutionary vertical print hinge I'm calling the “Impossible Hinge”. 

Original Impossible Bracelet available in three varieties: 

          Original size with 11.5mm and 19.5mm widths.

          19.5mm size scaled 75% for a less bulky look. 14.6mm width.

New! Available 12/31/24 - Impossible Bracelet 2 with a new link design in two varieties:

          Original size with 19.5mm width.

          19.5mm size scaled 75% for a less bulky look. 14.6mm width.

A single 11.5mm bracelet takes a little over an hour to print and a 19.5 takes closer to two hours on average depending on length. Each profile has 12 different lengths on 12 plates which is why the profile reports such long print times.

Profiles includes lengths of 144mm to 243mm with each size on its own plate. For sizing I suggest measuring your wrist and selecting a size 1 or 2 sizes higher. Profile includes a two color stripe design. Easy use of the Bambu Studio Preview tab to put in color changes for AMS or manual pauses to change colors without AMS. (Picture below)

Test printed in a variety of filaments. Bambu ABS: Red, White and Blue, Baby Blue and White, Black and Red, Rainbow, Gray Baby Blue Red Bambu PLA: Black and Gold, Gold Bambu PETG: Green, Black and Translucent Purple, Black and Translucent Blue

Note: Test prints in PLA Silk did not have enough strength. Not recommended. Bambu PLA or better strength material recommended.