Search models, users, collections, and posts
Fidget
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
46 min
1 plate
Open in Bambu Studio
Boost
4
14
0
0
7
1
Released
Description
An amazingly satisfying gear toy made to move smoothly and work on most printers, this design is made to be strong, fidgety and chunky, to satisfy all ages.
First print the gears. Then print the threads and about halfway through put the gears onto the threads (this may take a bit of time to get right) finally wait for the print to finish the bridging at the top, so the whole design is firm, and get fidgeting.
If that all sounds too complicated and fidgety (excuse the pun) just use the print in place version (sadly it may not be as strong.)
Also just use normal settings for both models
If you like this please consider joining my club for exclusive models and a commercial licence!
Enjoy!!!!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)