This a simple tool to unclog your nozzle, it should work on most 3D printer.
Made to use with 1.60mm rods, I used this one on aliexpress 1.60mm x 300mm,
100mm of the rod is embedded into the handle and is not usable.
No tool, glue or heatgun is required, simply screw it. It's a little tight to keep the rod in place, a drop of grease can help if needed.
The print profile use 2 colors and fuzzy skin on a section of the handle.
A end cap is provided to protect the end.
To create a 60° angle you can use this jig : https://makerworld.com/en/models/85020