If you like my work, i'm open for donations via Paypal. It is much appreciated.
https://www.paypal.com/donate/?hosted_button_id=3KZUPFUG4KLUL
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA Bambu PLA Blue Transmission Distance: 5
PLA Bambu PLA Red Transmission Distance: 5
PLA BambuLab Matte White Transmission Distance: 4
Swap Instructions:
Start with Black
At layer #4 (0.4mm) swap to Blue
At layer #8 (0.72mm) swap to Red
At layer #15 (1.28mm) swap to White for the rest.
Reminder:
My models mostly cover the entire bed,
this means the purge line is sometimes
running through the bottom of the print.
You have 3 options here:
- Leave as is, you can just cut them of afterwards.
- Remove immediately after the purge line is printed.
- Scale the model:
*** WARNING ***
WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT!
The Z-height must always be as original, otherwise the print
is messed up.