Gift Box by Benjamin Kott

Benjamin Kott

Household>Festivities

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

12x8x2cm

Designer

2.3 h

3 plates

4.8(17)

4x4x3cm

Designer

1.2 h

3 plates

4.9(7)

6x6x5cm

Designer

2 h

3 plates

4.0(3)

Boost

128

370

432

Released

Description

Small Gift Boxes in various sizes. The raw model is fully parameterized, feel free to adjust the sizes to your needs.

I hope you enjoy the design, please leave a comment/rating if you enjoy it or share your feedback!

Comment & Rating (32)

@jbritt1234

A great model. Parts fit well, just needed a slight bit of scraping with a exacto.

The designer has replied

@benjaminkott

Looks awesome!

@Jumper

Print Profile

4x4x3cm

Einfach Toll ! Die Box hat mich einen Tag vor Heiligabend vorm Einpackwahn bewahrt. Leicht zu drucken und genau so einfach zusammen zu stecken Ich sage DANKE

@NeoBlack

Print Profile

12x8x2cm

It looks great, nice for a voucher card or any small gift.

@Plazman

Print Profile

12x8x2cm

LOVE that’s it’s fully parameterized. I was able to dial in an exact fit for the gift. wish the parameter referred to the inner diameter and not the outer though. Also, the seal on the box is a bit overboard and doesn’t fit for me, even though I have a pretty accurate printer. I’d like to see it simplified to a simple bevel or cut out. Not the Ziplock-like design it is now. And maybe little pins to help the ribbon stay attached? Really nice though!

@antienoob00

Print Profile

12x8x2cm

printed without an issue, looks good however I found where the bow crosses underneath the fit is a little to tight and it isn't flush (this isn't a major complaint however due to the fact that the bump is small enough that for the majority of people wouldn't pay any attention to it). all in all an overall good print and worth the time if you have something to put into it.

(Edited)

The designer has replied

@benjaminkott

Thx, a lot for the feedback! I could not get rid of the small bump at the bottom (only on 2 sides of my prints, straight lines). There seems to be some support leftovers on the bottom causing the bump. I´ve used a sharp knife and flattened the overhangs a bit - after that, it should sit flush. There is already a tolerance in depth to counter this - but I was not able to get rid of it completely.

@csveal

Print Profile

4x4x3cm

Easy to print. Great design!