I needed a leg riser to give my P1S with anti-vibration feet just enough room to just fit between two Lack tables. The goal was to move the AMS onto the top table leaving room for expansion to more AMS units and have enough room above the printer to add a small riser to add light and allow for easier venting of the top glass. Most risers I found were either far to short or a bit taller that I really wanted. Knowing the top table would not be holding another print (right now), the infill and walls are a touch lighter than I originally decided to use but will be sufficient for the intended use. STEP file included to tinker with as you please.
12/7/23 UPDATE: I shifted some things around on the table stack and ended up changing out the foot pads on the printer. After doing this came to the realization that the new feet contact the riser bases so I have revised the design to give proper clearance.