Bicycle cribbage board replacement peg
Copyright Claim
Bicycle cribbage board replacement peg
Boost
15
20
7
Print Profile(1)
0.1mm layer, 10 walls (to make it solid)
14 min
1 plate
Open in Bambu Studio
Boost
15
20
7
0
73
82
Released
Description
This is a replacement part for your lost or broken Bicycle cribbage pegs
Recommended print settings:
Layer height: 0.1mm
Infill: Grid 15%
Speed:100.0 mm/s
Comment & Rating (7)
All
I cut the pieces lengthwise to make them flat on one side so I could print them easier. Not sure if that was needed, but it seemed helpful to me.
(Edited)
The designer has replied
0
Reply
Nice
0
Reply
Print Profile
0.1mm layer, 10 walls (to make it solid)
worked well now I can remove the nail that was being used.
0
Reply
Print Profile
0.1mm layer, 10 walls (to make it solid)
0
Reply
Print Profile
0.1mm layer, 10 walls (to make it solid)
0
Reply
Print Profile
0.1mm layer, 10 walls (to make it solid)
0
Reply
Print Profile
0.1mm layer, 10 walls (to make it solid)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld