Timberborn Levee

The Levee system from Timberborn!

The Dam and Sluice are coming shortly, but I wanted to get these base pieces uploaded first as they're the foundation for a lot of other buildings.

The 3mf file contains a lot of variants:

1. Straight Connected Levees (Connectors at opposing sides) in the following flavours:
   1. Top (connectors at bottom only for smooth top surface
   2. Middle (connectors at bottom and top, good for middle pieces of the wall)
   3. Bottom (connectors only on the top, optionally good for bottom pieces)
2. Corner Connected Levees (Connectors along two adjoining sides)
   1. Top
   2. Middle
   3. Bottom
3. 4-Way Connected Levees (Connectors on all sides)
   1. Top
   2. Middle
   3. Bottom
4. No Connected Levee (No connectors anyone, just a nice simple block)

Happy to make variants of this if anyone would find useful, though I think the above should allow for most use cases.

These connect into the existing Sluices and Dams!

The connectors are compatible with my Timberborn Power System So you're able to run the power along the Levees, as shown in the animation

Note, please leave Levees on 45 degree angle when printing as it will allow the top layer to have straight lines which looks a lot nicer as timber. It also prevented some oddness I found with a few layers. Also not supports, the printer was able to handle the 36mm bridge nicely.

If you were concerned with a lack of space with 45 degree I was easily able to print all 12 of the levees at once in the above gif, see below: