D10 Kitcard V3 00-90
Print Profile(2)
Description
Boost Me (for free)
Roll for boost!
Greetings fellow adventurers,
By popular request, I present to you the 00-90 percentile D10 kitcard!
This d10 measures 16.5mm face to face and counts from 00 to 90, featuring a layout of which the opposite sides sum to 90.
Assembly Instructions (no glue required):
The joints of the pieces feature a slight dovetail design and require a bit of pressure to push into place. Once assembled it is not recommended to disassemble again.
1. Carefully remove each piece from the frame.
2. Gently bend the faces of the pieces inward.
3. Connect the 40-face to the 70-face as shown below so the 10-face will connect to the 10- & 70-face.
4. Subsequently push the 10-face into place, then the 60-face and so on, alternating between the faces of the upper and lower part.
And there you have your new percentile D10!
Options:
In the print profiles you will find the following options:
- duo color (featuring a plate with frame and a plate without frame)
- single color (featuring a plate with frame and a plate without frame)
Materials:
These were designed and printed with PLA, but also work with PETG.
PETG doesn’t leave the fold lines you get with PLA. But you can remove the fold marks from PLA prints with a quick pass of a lighter. Just remember to exercise caution and be careful!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (12)