Small part drawer compartments
Copyright Claim
Small part drawer compartments
Boost
22
56
3
Print Profile(1)
0.24mm layer, 2 walls, 10% infill
Designer
13.1 h
1 plate
Open in Bambu Studio
Boost
22
56
3
0
66
10
Released
Description
Print in place organizer drawer. Design inspired/copied from Slant3D video(Linked below).
36 total compartments.
each tub is 32mmx32mmx90mm(90mm at the top, 50mm at the bottom)
No supports needed
Each compartment prints with a small tab at the bottom to keep them in place when pulled off the print plate.
just pull out the easily break the tab.
print takes about 9 hours in sport mode without any defects
included step. file of individual compartment for replacements or editing
Comment & Rating (3)
All
Print Profile
0.24mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 10% infill
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld