Scraper v1 by franceschellifederico

franceschellifederico

Tools>Other Tools

GIF

Print Profile(8)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

BambuLab Version - 0.2mm layer, 3 walls, 15% infill

Designer

6 h

1 plate

4.9(117)

Bambu Body Only - 0.2mm layer, 3 walls, 15% infill

Designer

52 min

1 plate

4.8(86)

Basic End Only - 0.2mm layer, 3 walls, 15% infill

Designer

16 min

1 plate

4.9(73)

No Logo Version - 0.2mm layer, 3 walls, 15% infill

Designer

5.8 h

1 plate

4.8(59)

Click to see more

Boost

598

1119

528

2.4 k

Released

Description

NOTE: USE MY PRINT PROFILE FOR BETTER RESULTS!

NOTE2: TOLLERANCE ARE CALCULATED FOR BAMBU PLA.

If you have any suggest, please don't esitate to leave a comment :)

Tip: Print the body and the final part in two different times if you don't want to waste time due to the AMS filament change :o

A re-usable scraper with a different end for any purpose!

I've designed a 3D-printable scraper tool that serves multiple purposes: cleaning and removing models from the printer bed after use and also for removing ice from car windshields during winter! What's unique about my scraper is the interchangeable end piece, offering a choice between three models: one for cleaning the printer bed, another for lightly iced glass, and the third for heavily iced glass.

Additionally, there's a slot (on the back) for 15x3mm magnets, allowing it to be attached to the side of the printer.

Green: lightly iced glass,

Blue: heavily iced glass,

Orange: cleaning the printer bed.

Comment & Rating (528)

@user_3748781154

Print Profile

Bambu Body Only - 0.2mm layer, 3 walls, 15% infill

Nice design. Unfortunately the handle broke off while installing the end part. Probably used to much force.

The designer has replied

@franceschelli

i'm sorry to hear that, what pla are you using? with bambu pla the end part goes in very easly

@franceschelli

you should try to print again the end part only using the x-y compensation.

@user_3748781154

Replying to @franceschelli :

I used Sunlu PETG for the handle. Will try again with your tips.Thanks.

(Edited)

@schiggy

Print Profile

Basic End Only - 0.2mm layer, 3 walls, 15% infill

fast good Print, but the tolerance works Not for every Material.

The designer has replied

@franceschelli

Did you read the description?

(Edited)

@schiggy

Replying to @franceschelli :

jep, i read the discription. i used pla from another Brand and wrote an obejctive Review. no Need for u to be mad. normaly u can use every pla and its working. if u cant deal with such an review, than Report instead of working on Modell so everyone get good results.

(Edited)

@franceschelli

Replying to @schiggy :

I think you are a novice, it is clearly written in the description that the tolerances are calculated for Bambu pla. if you have a different pla then change the x-y compensation instead of complaining. I hope I have been of help to you 😃

(Edited)

@BennyBoots

Print Profile

Basic End Only - 0.2mm layer, 3 walls, 15% infill

this is probably the best scraper there is. the replaceable blades, that alone, is a terrific design. thank you. i may try printing the blades in petg to see if those are even stronger and maintain their sharpness better.