sodyeK

cover

IMG_2711.jpeg

plate_1.png

plate_2.png

Broccoli

IMG_20250514_005555.jpg

IMG_20250514_005603.jpg

IMG_20250514_005612.jpg

IMG_20250514_005635.jpg

IMG_20250514_005728.jpg

IMG_20250514_005736.jpg

IMG_20250514_005750.jpg

💠Disable Z-Hop:<ul><li> Offers almost no benefits in this print</li><li>Increases stringing but still no problem for this pring</li></ul>&nbsp;💠Enable “Avoid Crossing Walls”:<ul><li>Set to a value 200mm to prevent the extruder from crossing inner walls, leading to cleaner inside surfaces.</li></ul>&nbsp;💠Disable Brim:<ul><li>If the bottom surface area is large and has no sharp corners.</li></ul>&nbsp;💠Global Setting Change:<ul><li> In &#34;Quality&#34; settings, set all line widths to a higher value (e.g., 0.5mm for a 0.4mm nozzle). This can go up to 0.6mm with a 0.4mm nozzle with minimal quality difference for models without small details. ( current set to 0.6mm)</li></ul>💠Compensate with Wall Count:<ul><li>Reduce the wall count by one (e.g., from 3 to 2) to keep overall wall thickness nearly the same. This significantly reduces print time.</li></ul> Results :&nbsp; 🟢 Printing time reduced by more than 50 minutes and cut in half overall.  🟢 Sturdy structure due to thick walls

0.2mm layer, 2 walls, 15% infill, ZigZag

This controller stand holds two controllers of almost every kind.Tested with: Xbox OnePlaystation 4GamecubeXbox 360Nintendo Switch Pro Controller&nbsp;Slides and snaps together. Print pictured was made on a Creality Ender 3.Make take some superglue to hold the back on if there is warping, which is what I had to do, but I use it every day with no issues.

Print Profile(1)

Description

Comment & Rating (26)

License

Remixes (1)

Related Models

Teired Controller Stand