Dragon Skull - Stability Remix
Remixed by
Copyright Claim
Dragon Skull - Stability Remix
Remixed by
Boost
69
126
29
Print Profile(2)
Original - Medium (200%)
Designer
6.2 h
1 plate
Original - Small
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
69
126
29
4
144
133
Released
Description
Loved this design from Printed into Existence, but it never sat stable on flat surfaces.
I've sliced off the bottom and set the jaw to 100% infill to improve the stability of the design for display on desks or shelves without a stand.
Supports near the back of the skull have been tricky to get right without using support material, which I know not everyone has access to, so the profile I've uploaded has my manual supports that I've found work best for me.
Comment & Rating (29)
All
Amazing print. Points came out sharp, and skull had great detail.
0
Reply
Print Profile
Original - Medium (200%)
sweet skull will probably paint later black looks good though!
0
Reply
Boosted
Print Profile
Original - Medium (200%)
should use gyroid infill. I had a layer shift while printing.
The designer has replied
0
Reply
on which model printer? infill pattern shouldn’t cause layer shift, but I have seen the gcode get sliced with a layer shift on an older firmware of the P1 series.
0
Reply
Boosted
Replying to @JakeMakes
Brand new X1C
0
Reply
This comment applies to the "Original - Small" version (for the A1 Mini).
PSA: Beware - Very sharp, pointed edges. The more you know. :-)
(Edited)The designer has replied
1
Reply
yes! lol, I do not recommend stepping on them 😅
0
Reply
Print Profile
Original - Medium (200%)
Printed out much better than I thought it would, also larger than i was expecting. Keep up the good work and I look forward to any future models. Thank you
1
Reply
Boosted
Print Profile
Original - Small
was a little hard to get supports off but came out great!
0
Reply
Print Profile
Original - Medium (200%)
no issues :)
0
Reply
Print Profile
Original - Small
nice details
0
Reply
Print Profile
Original - Medium (200%)
very detailed and looks great
0
Reply
Print Profile
Original - Medium (200%)
Very cool! printed perfectly.
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld