Godzilla Hueforge

Project: Godzilla.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 169.81x240mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
PLA Bambulab Black Transmission Distance: 0.3
PLA Rosa 3D Starter grey Transmission Distance: 0.6
PLA Bambulab White Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4.1
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to grey
At layer #11 (0.96mm) swap to White

Border Only Colors from here until the end.
At layer #18 (1.52mm) swap to Red
At layer #29 (2.4mm) swap to White for the rest.