Wall Planter with hidden drip tray and command strip mount - 70mm
Wall Planter with hidden drip tray and command strip mount - 70mm
Boost
29
73
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
29
73
16
1
164
129
Released
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed using Spectrum Stone filament.
The designer has replied
1
Reply
looks super
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great little concept, only stumbled across it as i was looking for a simple seed growing plant pot ! I would have liked it to be larger, I know there is a way to scale it up, however my skills are in the early stages. Thank you very much.
The designer has replied
1
Reply
ill scale it 200% soon
0
Reply
Jay, you can arbitrarily scale any model in the slicer without needing the creator to do it for you.
With a part selected (or multiple parts, selected by clicking while holding ctrl) the toolbar will enable the scale button, which is the 10th button from the left, or two right from the 4-arrow move control (see attached piccy).
You can either drag one of the corners to make the part(s) bigger or smaller, or type a percentage of the current size to do the same thing. By default, the model will be scaled uniformly on all 3 axes, preserving its proportions.
On an X1 or P1, it looks like the biggest you can make this model is about 125% and still have all the parts fit on one plate. You can make it a good bit bigger then press the arrange object button (4th from the right) to automagically have the parts be arranged across multiple plates. It looks like you can go up to 145% and have it print on two plates; above that requires three.
(Edited)
1
Reply
Replying to @Smeg.Head
Yeah but the command strip design will be enlarged aswell which you do not want. I will recreate some plant potters i have soon and offer 2/3 sizes for free.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great model. Looks great and scales well in the slicer
1
Reply
Printed this overnight. Great print. I wish I had some marble filament to have achieved the intended look, but it still turned out nice. I enlarged the size a bit, but shouldn't have. Now, I don't think command strip will work. I might be able to do something with velcro/hook and loop instead.
Thanks for sharing!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfetto
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld