Xtouch tempreature sensor holder for DS18b20 and press in magnets
Remixed by
Copyright Claim
Xtouch tempreature sensor holder for DS18b20 and press in magnets
Remixed by
Boost
9
10
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
9
10
8
0
55
50
Released
Description
This is a remix of the wonderful chamber temperature sensor holder https://makerworld.com/en/models/19658#profileId-18389
I've made it taller so the sensor might slide in without needing to snip the lead legs of the parts that are attached to the board.
I've also added holes for 6x2mm magnets 6x2mm
Comment & Rating (8)
All
Worked perfectly! The magnet are a little hard to pushin but you'll be sure they never come off.
The only issue if the cap that dont fit firmly so i have to glue it in place.
Thanks!
0
Reply
May I ask which interface should the other end of the thermometer data cable be connected to on the esp32 motherboard?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Now my temp is showing on my X1!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
No issues printing or mounting the part inside
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works but the cap was a little loose
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld