Christmas tree with star
Remixed by
Copyright Claim
Christmas tree with star
Remixed by
Boost
28
36
5
Print Profile(1)
0.2mm layer, 2 walls, 5% infill
Designer
3.4 h
2 plates
Open in Bambu Studio
Boost
28
36
5
0
78
81
Released
Description
Made a star for christmas three.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 5% infill
Looks good, though the star printed without supports and the attachment was all messed up so had to glue it to the tree instead.
1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
great tree, made a lot of them for at the office next christmas 😜
0
Reply
Looks great! Need to add supports in slicer.
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
it came out great. I scaled it down to 75%. I forgot to enable supports on the star but snipped off the droopy bits and still was able to glue it into place.
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld