https://makerworld.com/en/models/81906#profileId-87161
At the same time this calibration cube will serve its purpose. This calibration cube is a classic 20mm cube on x, y, and z axis.
I made the Bambu logo at front x-axis, MakerWorld log on the right side – y aixs. (PS: If you can't get the dimension you want, push hard, until you get the number that you want,,, lol)
Due to the shrinkage rate of your filament, some deviations are acceptable. Some filaments like wood filament very often will over size.
The Bambu logo at front (x axis) will display some quality of detail finish and the printing quality over small parameters.
At the same time those edges will show if there is any ghosting issue.
On the other right side (y axis), we have MakerWorld logo. Which consists of a small floating layer, over top, and some small vertical overhang.
I have left two surface black, so you can check out the layer finish.
Light and observe postition (angle) matter a lot here:
At top
On side (45degree)
Can you see how big of different from same surface.
Some filament are really good on hiding layer lines:
Over extrusion (overflow) will have ugly surface finish.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.