Search models, users, collections, and posts
Maslov Statue
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
23
50
3
4
39
21
Released
Description
Content has been automatically translated.
Disclaimer: This is not an original creation; the website upload prohibits sharing, only allowing the selection of 'remix'.
This model is available on Sketchfab. I couldn't stand seeing people overcharging for it on Xianyu; the cost is only a few yuan to produce.
The tree requires manual support settings or the arm is prone to breakage. Do not use inferior silk filament or you'll experience the same issue.
Based on my experience, the sword area requires a slower print speed. I suggest adding a support block and increasing the print speed to 30 for this section.
I've printed this model myself, but the inferior filament caused it to break. Avoid cheap, generic brands; refer to the group recommendations for filament.
Comment & Rating (3)