Advent Calendar

This is the advent calendar that I have designed to my liking, with five larger boxes so that it has greater capacity.

Inside the boxes can fit Playmobil figures, Bricks, candies and everything you want to give to your child!!

Approximate assembled dimensions:

• 440 mm Tall / 256 mm Wide / 55 mm Deep

Approximate interior dimensions of the boxes:

• Square box: 40 mm x 43 mm x 42 mm
• Rectangular box: 87 mm x 43 mm x 42 mm
• Vertical rectangular box: 40 mm x 90 mm x 42 mm

For reasons of the size of the house, it cannot be printed on the A1 mini (unless you want to scale it but I don't know what the result will be).

Print Instructions:

• All printing plates are in the same file, with all the parts that are necessary (no part has to be cloned).
• The AMS is not necessary, since to print the number pieces, you only have to add a pause at layer 9.
• The piece of the roof with snow on the right side (with the chimney hole) has a small support.
• You must try to have the printing plate clean and with adhesion product, since in large pieces of the house, it is easy for the tips to come off and ruin the printing.
• The decorative clock is in a separate file in the RAW section, since if you want to print it it has to be with the 0.2 mm nozzle.

Assembly instructions:

• The house is divided into two parts, it is assembled using the guide and glued together:

  

• The central snow is also glued with the help of centerers:

  

  

• The roof is made up of two pieces, with snow on the front of the house. Care must be taken to glue the pieces flush with the back of the house, leaving a small space between the snow and the house (the space is necessary for the central snow piece and to give a little depth effect to the roof). You should also ensure that the two pieces of the roof stick together at the top:

• The chimney and the chimney snow are also glued together with glue and are assembled taking into account first introducing the lower edge of the chimney into the gap provided by the roof snow:

• The pieces with the numbers are assembled to the boxes using the box guides and I have glued them with a little glue so that it is well fixed and closed:

• The ornament at the top has a centerer to make it easier to stick with glue. I have put three different models, but you can also put whatever comes to mind, taking into account the dimensions of the centerer (10 mm diameter x 1 mm depth). The watch requires using the 0.2 mm nozzle.

• Arrange the boxes however you want and combine the colors however you like!!