Small Parts Tray with Lid by Wiseone

Wiseone

Tools>Organizers

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

Small Parts Tray 0.2mm layer, 2 walls, 15% infill

Designer

1.7 h

1 plate

4.6(7)

Open in Bambu Studio

Boost

Released

Description

A small tray with sub-divides for small parts, like screws, etc. The overall tray size is 58.75 by 131mm and 28.25mm high. The lid presses on.

My print is made with eSUN PLA+ 1.75mm red filament, with 0.2mm layer height and 15% infill on a Bambu X1 Carbon printer. No supports required.

I hope that you can find this print useful, too.

Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.

UPDATE

07/03/2024 Corrected the lid to properly mate with the tray.

container

Comment & Rating (13)

@mrunion

This piece printed very well and the top fits very tightly on the base. Maybe a bit too tight?!? Printed on the X1C in PLA. Timelapse here: https://youtu.be/B0EGxcbgyCE

(Edited)

The designer has replied

@Wiseone

Nice print. Thanks for your feedback. With regards to the tight lid fit, I found that the fit loosens quickly with use.

@user_4114387627

Print Profile

Small Parts Tray 0.2mm layer, 2 walls, 15% infill

Nice little box with a lid, but the lid doesn't fit properly. The corners of the compartments are curved, and on the bottom of the lid they are all 90° angles, so you can't put the lid in place.

Other Issues

The designer has replied

@Wiseone

Hi. Thanks for bringing the lid fit problem to my attention. Not sure how I missed that, so apologies to all who had difficulty with the lid fit. I believe I have corrected the lid design. If not, please bring it again to my attention.

(Edited)

@user_4114387627

You're awesome, thank you so much. I'll print it again. I'm still a noob to 3d printing, so I don't even have a clue about how to actually make any kind of models of my own yet. I appreciate you replying back to my post on this.

(Edited)