Search models, users, collections, and posts
i-Tec U3CHARGEHUB16 USB Hub Plate Holder
IP Report
Print Profile(2)
0.16mm layer, 2 walls, 15% infill, support.
Designer
59 min
1 plate
4x FLAT ABS, 0.16mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
1
3
2
0
17
10
Released
Description
CeDeROM's [1] wall mount for 16 port USB 3.0 HUB from i-Tec model name U3CHARGEHUB16 [2]. Created for NuttX RTOS [3] distributed build and runtime test farm in order to connect various electronic boards and devel-kits to a single build host. Electronic devices are mounted on a wall board where bread-boards are mounted so I also needed to mount the USB HUB somehow :-)
Design is symmetrical so it fits both sides of the device, can be printed in horizontal and vertical alignment (support recommended), can be easily cloned on the plate to have many prints on a single plate. Use horizontal alignment for increased strength (ABS profile provided). Use M3x20 screws :-)
I hope you find it useful too, have fun! :-)
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (2)