Ikea skadis spray bottle holder
Copyright Claim
Ikea skadis spray bottle holder
Boost
11
39
5
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
33 min
1 plate
4 walls, Cross Hatch infill
42 min
1 plate
Open in Bambu Studio
Boost
11
39
5
0
34
22
Released
Description
I created this holder especially for the Pepprig bottle from IKEA. But I think other bottles will also fit.
The lower part visible in the photo is only there because my Skadis board is placed at an angle so you probably don't need it
Check out my other ikea skadis models!
Comment & Rating (5)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Works great. Printed PETG transparent strength setting.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
useful! but a bit rough at the under side
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld