Missile Toad

Copyright Claim

Missile Toad

Boost
68
105
46

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 5% infill
0.2mm layer, 2 walls, 5% infill
Designer
9 h
1 plate
4.8(33)

Boost
68
105
46
2
213
181
Released

Description

I have no clue who the original designer is of this file since its been in my collection for well over a year. If any one knows let me know ASAP please would love to give them credit

 

Now what i have done was pre paint this bad boy for the Holiday times because hand painting them is in the past, we have multi color printers now. Enjoy and spend the nice afternoon cuddled up under the Missile Toad by a warm fire and a nice hot cup of cocoa.

 

I have this print set to do the outer walls slow for a nice finish with most basic PLA filaments, other than that i normaly set my plate to make 10 at a time.

 

Please leave feed back.

 

Comment & Rating (46)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 5% infill
You are toadally awesome. Thank you for doing this. Print came out great, and like noted below, everyone wants one now. (And who wouldn't?!) Only issue I noted was on the left side of the missile, on one of the wings, prints with gaps where it attaches the toad. The right side is solid. Looks like it's the same with a couple of the other photos below too. That may just be the original model, though. Here's a couple of photos, if it helps.
The designer has replied
1
Reply
I'll try to see if I can. solve this latter today.
(Edited)
1
Reply
Everyone at work wants one lol
The designer has replied
1
Reply
Heck yeah! keep the people happy.
1
Reply
Love these guys. Thanks for sharing.
The designer has replied
1
Reply
Love the color. Nice work!
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
Turned out great.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
very cute 10/10
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
love them!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
printed great from the profile!
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
0
Reply
pretty sure it’s a Hex3d file
The designer has replied
0
Reply
It's definitely not the Hex3D one, here is a picture of his version.
0
Reply
my mistake buddy
0
Reply
Nah, just another copy
0
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
not too bad just very minor bleeding of color
The designer has replied
0
Reply
Where is it bleeding at? Have a picture you can upload? Also what brand fillment are you using?
0
Reply
Replying to @Christopher907 :
getting a tiny bit of ted in the white part of the missle on the frogs left side by the middle fin
0
Reply
Replying to @Sscigg :
Strange I'll update the file, but everything on my slicer shows Red starting at layer 183 and that's near the top of his head when the inner red ring on the Missile starts.
0
Reply